ep

January 20, 2021

Electrical power UNITS FOR LIFT TABLE 1
General Description
This energy unit is built solely for the little lift table,Consisting of high strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has become widely used from the market of logistic units for example minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is controlled by the solenoid valve using the velocity controlled by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Basic Description
This energy unit is built exclusively for the medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve as well as the pace managed by the adjustable needle valve. When the lift rises to a large positoin, but the power provide is cut, the lowering motion is controlled from the manual override function.
Electrical power UNITS FOR LIFT TABLE 3
Basic Description
This energy unit is built solely for your substantial lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve as well as the velocity controlled by a strain compensated flow handle valve.
Energy UNITS FOR LIFT TABLE 4
General Description
This electrical power unit is designed exclusively for your large lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve as well as pace managed through the adjustable needle valve. When the lift rises to a large positoin, but the energy provide is minimize, the decreasing motion is controlled from the manual override function.
Exclusive Notes
one. This power unit is of S3 duty cycle, which could only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean every one of the hydraulic parts concerned just before installation of the power unit.
3. Viscosity in the oil shoud be 15~46 cst,which should really also be clean and totally free of impurities.N46 hydraulic oil is proposed.
4. Oil shifting is required immediately after the original a hundred operation hours,afterwards the moment each 3000 hrs.
5. The power unit shown is created to be mounted vertically.